BLR Vortex Generators
We are convinced that this kit is the single
most effective performance enhancement for a Super Cub.
5-6 mph reduction
in stall speed!
Where else can you gain this type of
performance! You can expect increased performance, increased safety,
better aileron control and shorter landings!
The kit consists of 18 pairs of vortex
generators per wing, six of which are offset forward on the outboard section
of the wing. There are also two strakes mounted on the sides of the
fuselage just forward of the horizontal stabilizer.
At slow speeds the vortex generators create
miniature vortices which compress the boundary layer by
approximately 60%. This compression increases the energy within the
boundary layer which forces it to remain attached to a
higher angle of attack. By delaying the separation of the airflow
the aircraft is able to reach a higher angle of attack and slower
speed before a full stall occurs. When a full stall does occur it is more docile, and reattachment of the airflow is accelerated
during stall recovery.
Two triangular tail strakes create very large
and powerful vortices which increase the energy of the flow over and
under the horizontal stabilizer. The flow is forced to remain
attached thus preventing loss of control during skidding turns.
Experience a widely expanded safety margin
and tremendous STOL performance!
|
KITVG-18
$1,495.00
PA-18 Vortex Generator Kit
5-6 mph reduction in landing speed, tremendous added aileron authority, and spin resistance. Install in less than a day. Best STOL performance mod available.
KITVG-Cessna
$1,495.00
Vortex Generator Kit, Cessna 180-185, 182, 182P, 182T
Cessna with Delta wings: C180 (180J and up), A185F and up, 182P and 182T
Cessna w/o delta wings: 180-180A, B C, D E, F, G, H, 182-182A, B, C, AND D and 185-A185A, B, C, D, AND E
KITVG-C120
$1,495.00
Vortex Generator Kit for the Cessna 120 and 140
KITVG-12
$1,495.00
PA-12 Vortex Generator Kit
KITVG-14
$1,495.00
PA-14 Vortex Generator Kit
|